|
WATER
PUMP LIMITED WARRANTY
PRO VALUE
water pumps are warranted to be manufactured free of defects in materials and
workmanship. This warranty is good
for a period of one year from the date of sale, and is non-transferable.
The warranty is redeemable by the original purchaser only.
The decision for repair or replacement is the sole responsibility of PRO
VALUE.
The warranty
is void for items disassembled or tampered with.
The warranty is also void if the vehicle has been modified from the
original manufacturer design, or has been used for racing purposes.
This warranty does not cover any failure due to faulty or improper
installation, accidental damage, abusive use, neglect, or normal wear and tear.
The liability
of PRO VALUE shall not exceed the original purchase price.
PRO VALUE shall not be held responsible for consequential damages,
personal injury, or property damage. This
statement is the exclusive expression of warranty by PRO VALUE, and is in lieu
of any and all other warranties, whether expressed or implied.
No modifications of this warranty are authorized, nor are promises,
terms, conditions, or warranties other than those contained herein.
PRO VALUE reserves the right to make changes, modifications, or
improvements in the part without incurring any obligation to similarly alter,
modify, or improve products previously procured.
GENERAL TERMS:
-
Purchaser
must present original sales receipt before warranty will be authorized.
-
Purchaser
must first call PRO VALUE customer service for authorization to return
defective item(s).
-
All parts
must be returned.
Failure to follow installation instructions will void this Warranty.
Purchaser must follow approved installation processes for this warranty
to be in effect:
-
Clean the
entire cooling system, including the engine cavity and gasket surface.
Flush the system until the fluid drained is clear.
-
Carefully
position new gaskets (where applicable) when mounting the pump.
-
Tighten
the pump bolts properly, checking tightness using a torque wrench.
Tighten the bolts in a criss-cross pattern.
-
DO NOT
STRIKE THE SHAFT, either through hitting or dropping the pump on a hard
surface.
-
Turn the
pump by hand after mounting the pump, but before installing the belts.
-
Inspect
and/or replace the thermostat or radiator clamps if they are sticking or
leaking.
-
Inspect
and replace any hoses, belts, or clamps that are worn or otherwise
defective.
-
Replace
coolant with fresh approved fluid, properly diluted if required.
-
Inspect
and replace any fan with cracks, bends, loose rivets, etc.
NEVER try to straighten a bent fan, as this provides risk of damage,
injury, or death.
-
Replace
any fan clutch, tensioner, or pulley that appears damaged, imbalanced, or
out of alignment.
-
Once
everything is in place, and checked for the above and any other installation
requirements, start the engine and run it to normal temperatures.
Check the pump for smooth operation and the coolant system for proper
fill levels.
-
Turn off
the engine and check for leaks, exercising care not to be burned.
 |
